Hello. First let me apologize if this issue has been covered. I was unable to locate a satisfactory answer to my question, but I realize that doesn’t mean it doesn’t exist. I’ve been tinkering with RetroPie for a few months now. I have created RetroPie consoles from 1st and 2nd generation Pi boards. The issue I’m having as far as controller configuration on my Pi2 is a bit of a head scratcher though. For my first gen board, I just used a pair of SNES imitation pads which connected via USB and they worked without issue. However, since the Pi2 is more powerful, emulation of 3D capable systems is far more practical, and I therefor opted to use the Logitech F310 pads which have joysticks and the same amount of buttons as a PSX controller. The issue is when I go to program the buttons in the EmulationStation GUI, it doesn’t correctly recognize the analog triggers. It seems to interpret pressing the trigger and releasing the trigger as separate button presses, so I therefor cannot complete the configuration of the controllers correctly. When I use the RetroPie-Setup script, the button order turns out wrong when I launch a game in EmulationStation. For example when I use the PSX emulator, the button mappings don’t match the layout of an actual PSX pad. I did find that the Logitech Dual Action pad (basically a previous version of the F310) works great, but they are nolonger manufactured and typically go for ridiculous prices new. I’m hoping there is a quick and easy solution to this problem but any help will be greatly appreciated. Thanks for any assistance you can offer.
